High Flow Series Cartridges

Graver High Flow Series Filters feature a larger geometry to handle higher flows with fewer filter elements. The result is much faster, easier filter changeouts. In addition, the inside to outside flow allows for excellent dirt holding capacity, extending the time between filter changeouts. Filter housings are also available and because of the filter high flow and dirt holding capacity, smaller systems are possible, reducing upfront capital costs.

Compatible with most common chemical cleaning, sanitizing and sterilizing agents and with pH range from 1-14. Consult factor for specific compatibility information. Cartridge will withstand up to ten 30 minute hot water cycles at 181°F (83°C) at 5 PSID (0.35 bar)

6” Diameter, large geometry for high flow rates
Absolute retention ratings from 1 to 100 microns
Capable of flow rates up to 500 gpm in a dingle 60” element
Inside-out flow retains contaminant even during changeout
Multi layer pleated construction with optimized surface area
Outer cage prevents media extrusion problem experienced with some competitive offerings
Unique Quad Seal gasket provides maximum seal integrity
Retrofits competitive high flow filter housings
Thermally bonded construction

Water Systems
Chemicals
Food and Beverage
Pre RO

Below is all information pertaining to the High Flow Series Cartridges:

High Flow Cartridge Filters

Cannot find the configuration you are looking for? We would be happy to issue you a formal quote with exactly what you need.